MICRO SD TF Card Module 6Pin Micro SD Card

Summary

Features:

1. Support Micro SD Card, Micro SDHC card (high-speed card)
2. The level conversion circuit board that can interface level is 5V or 3.3V
3. Power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
4. Communication interface is a standard SPI interface
5. 4 M2 screw positioning holes for easy installation
6. Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO,
7. MOSI, SCK is the SPI bus, CS is the chip select signal pin;
8. 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply
9. Level conversion circuit: Micro SD card into the direction of signals into 3.3V, MicroSD card toward the direction of the
10. control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal
11. Micro SD card connector: yes since the bomb deck for easy card insertion and removal
12. Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve
13. inter-module combination
14. Mirco SD Card Interface Module:
15. -Control Interface : A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground , VCC is the power supply ,
16. MISO, MOSI, SCK is SPI bus , CS is the chip select signal pin
17. 3.3V voltage regulator circuit : LDO regulator output is 3.3V level converter chip , Micro SD card supply
18. Level conversion circuit : Micro SD card into the direction of the signal is converted to 3.3V, MicroSD card interfaces to
19. control the direction of the MISO signal is also converted into 3.3V, general AVR microcontroller system can read the signal;
20. Micro SD card connector : a self- bomb deck , easy card insertion .
21. Positioning holes : 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install , to achieve inter- module combination.